Verkorte levertijd

• Spoedmontage binnen één werkdag - als alle vereiste onderdelen beschikbaar zijn (weergegeven afhankelijk van de individuele
  afhankelijk van de individuele configuratie), vindt de montage plaats op werkdagen tussen
  van 8:00 tot 14:00 uur. De verzending vindt dan zo snel mogelijk plaats. Deze optie is
  voorwaarde voor expreslevering.
• zonder expresmontage - montage en verzending binnen 3-4 werkdagen

Asontwerp

Installatiepositie

De installatiepositie is nodig om de hoeveelheid smeermiddel te bepalen.
De aanduidingen voor de verschillende installatieposities vindt u in de volgende afbeelding.

Positie van de aansluitdoos

De positie van de aansluitdoos (0, 90, 180 en 270°) en de positie van de kabelinvoer (A, B, C
en D) kunnen als volgt worden geconfigureerd:

Fuv variant

There is a choice of different dimensions (see data sheet). This allows
and hole pattern of the mounting holes can be adapted to the 1:1 exchange of various competitor makes.
competitors.

Motor protection and brake

The attached three-phase motor can be configured here

The following options are available for monitoring the winding temperature of the motor:

a) with 1 set (3 pcs.) of PTC thermistors - for monitoring with PTC thermistor tripping device or frequency inverter

b) with 1 set (3 pcs.) of microthermal switches (NC contact) - for monitoring e.g. with motor protection relay

The selection of one of these options is recommended when operating the geared motor on the frequency inverter,
as reduced speeds and the associated lower cooling capacity can cause the motor to overheat.
motor may overheat.

External fan

a) without - standard
b) with forced cooling fan (available from motor power 0.12kW)

Use of a forced cooling fan - e.g. when operating on a frequency inverter - to prevent the motor from overheating
due to the lower cooling capacity at reduced speeds.
Forced cooling fan voltage: 230V/50Hz/1~
Protection class: IP55

Combination of motor with brake and remote fan on request

Lubricant

a ) Synthetic high-performance gear oil with the specification CLP PG VG320For use under severe conditions and long maintenance intervals

b) Synthetic food grade high performance gear oil with the specification CLP PG VG320 NSF H-1. For use under severe conditions and long maintenance intervals. Certified to NSF H-1 and therefore approved for use in the food industry (occasional food contact)

c) Without oil - for filling by the customer. Further recommended oil types and filling quantities can be found in the operating and maintenance instructions.