Plazo de entrega reducido

• Montaje exprés en un día laborable: si se dispone de todos los componentes necesarios (se muestra en función de cada
  dependiendo de la configuración individual), el montaje tiene lugar en días laborables entre
  de las 8:00 a las 14:00 horas. El envío se realiza lo antes posible. Esta opción es
  condición previa para el envío exprés.
• sin montaje exprés - el montaje y el envío tienen lugar en un plazo de 3 a 4 días laborables

Housing version

a) Basic slip-on version - for use with customer-side torque support

b) Slip-on version with torque support - the torque support can be mounted in various positions on the
the threaded holes on the output side in various positions

c) Guide version - selection of laterally screw-on discs with different dimensions (see
dimensions (see data sheet) for mounting in different positions

d) Flange design - screw-on output flanges in various sizes - for dimensions see
data sheet

Connection side

For versions with a solid output shaft, flange and torque support, the position of the connection side must be
must be specified.

Installation position

The installation position is required to determine the quantity of lubricant.
The designations for the various installation positions can be found in the following illustration.

Terminal box position

The position of the terminal box (0,90,180 and 270) and the positioning of the cable gland (A, B, C
and D) can be configured as follows:

Shaft design

As an option to the hollow shaft with keyway, single and double-sided stub shafts with keyway can be used.
can be used. The stub shafts are fitted with a retaining ring. For dimensions and fits, see
data sheet.

Motor protection and brake

The attached three-phase motor can be configured here

The following options are available for monitoring the winding temperature of the motor:
a) with 1 set (3 pcs.) of PTC thermistors - for monitoring with PTC thermistor tripping device or frequency inverter
b) with 1 set (3 pcs.) of microthermal switches (NC contact) - for monitoring e.g. with motor protection relay

The selection of one of these options is recommended when operating the geared motor on the frequency inverter,
as reduced speeds and the associated lower cooling capacity can cause the motor to overheat.
motor may overheat.

c) with brake (available from 0.09kW)
Brake voltage 230V/50Hz/1~
The respective braking torque on the drive motor is displayed on the option. By multiplying by the
ratio i results in the braking torque on the output shaft of the gearbox.