Housing design

• Base version - standard version with mounting holes on 4 sides of the housing

• Flange design - bolt-on output flanges in various sizes - see data sheet for dimensions

• Slip-on version with torque support - The torque support can be mounted in various positions on the tapped holes on the output side

Shaft design

As an option to the hollow shaft with keyway, single and double-sided stub shafts with keyway can be used. The stub shafts are fitted with a retaining ring. For dimensions and fits, see data sheet.

Installation position

The installation position is required to determine the lubricant quantity.
The designations for the various installation positions can be found in the following illustration.

Input flange for IEC add-on motor

Selection of available flanges for the attachment of IEC standard motors. Variants:

a) for B14K (flange with threaded holes, small version)
b) for B5 (flange with through holes)

- Note: Select suitable coupling for input shaft as required -

Coupling for input shaft IEC add-on motor

Patented and robust coupling module for selecting adapters for different input shaft diameters.

- Note: Select the appropriate IEC input flange for the input shaft as required.

Product example shows worm gearbox, round design with coupling module

Assignment of shaft diameter according to IEC design