Reduction of delivery time

• Express assembly within one working day - if all the necessary components are available (indicated in
  depending on the individual configuration) the assembly takes place on working days in the time from
  from 8:00 to 16:00. The shipment will be made at the next available time. This option is
  prerequisite for express shipping.
• without express assembly - assembly and shipping are carried out within 3-4 working days.

Mounting position

The mounting position is required to determine the lubricant quantity.
The designations for the various mounting positions can be found in the following figure.

Terminal box position

The position of the terminal box (0,90,180 and 270) and the positioning of the cable gland (A, B, C
and D) can be configured as follows:

Fuv variant

There is a choice of different dimensions (see data sheet). This allows
and hole pattern of the mounting holes can be adapted to the 1:1 exchange of various competitor makes.
competitors.

Motor protection and brake

Here the attached three-phase motor can be configured

• without motor protection and brake - standard

The following options are available for monitoring the motor winding temperature:

• with 1 set (3 pcs.) of PTC thermistors - for monitoring with PTC thermistor tripping or frequency converter
• with 1 set (3 pcs.) of micro thermoswitches (openers) - for monitoring e.g. with motor protection relays.

The selection of one of these options is recommended when operating the gearmotor on the frequency inverter,
as reduced speeds and the associated lower cooling capacity can cause the motor to overheat.
motor may occur.

• with brake (available from 0.09kW)
  Brake voltage 230V/50Hz/1~
  The respective braking torque at the drive motor is displayed at the option. By multiplication with the
  The braking torque at the output shaft of the gearbox is obtained by multiplication with the gear ratio i.

External fan

a) without - standard
b) with forced cooling fan (available from motor power 0.12kW)

Use of a forced cooling fan - e.g. when operating on a frequency inverter - to prevent the motor from overheating
due to the lower cooling capacity at reduced speeds.
Forced cooling fan voltage: 230V/50Hz/1~
Protection class: IP55

Combination of motor with brake and remote fan on request

Lubricant

a ) Synthetic high-performance gear oil with the specification CLP PG VG320For use under severe conditions and long maintenance intervals

b) Synthetic food grade high performance gear oil with the specification CLP PG VG320 NSF H-1. For use under severe conditions and long maintenance intervals. Certified to NSF H-1 and therefore approved for use in the food industry (occasional food contact)

c) Without oil - for filling by the customer. Further recommended oil types and filling quantities can be found in the operating and maintenance instructions.